Skip to content
SMALL GEAR. BIG POSSIBILITIES.Meet PBGGAME
YOUR WISHLIST (0)

Saved on this device.

SAVE YOUR NEXT MOVE

Tap the heart on any product to keep your training essentials together.

EXPLORE PRODUCTS

FIND YOUR EVERYDAY MOVEMENT

BARBELL JACKS.

Compare the compact lever jack, set-of-2 option and jack stand shown below. Check the selected package, fit where the jack contacts your bar and model instructions before loading.

1–3 of 3 products

EQUIPMENT & TRAINING GUIDE

CHOOSE A JACK FOR YOUR BAR AND PLATE-LOADING SETUP

Start with the format and selected package. This collection shows a compact lever jack, an option labelled set of 2 and a jack stand. A pack label does not describe how many bar contact points a design has or how it must be assembled. Read the selected product's contents and model instructions before comparing packages; barbells, plates and tools are separate unless that product explicitly lists them as included.

Check fit where the jack contacts the bar. An Olympic bar or 2-inch plate label does not establish a cradle opening, supported shaft diameter or usable lifting height. Confirm the permitted contact position and the clearance needed for your plate diameter, floor and handle movement. Do not assume the same setup works for a specialty bar, a different shaft finish or every jack in the grid.

Treat load and size information as specific to the model. The linked jack stand lists overall dimensions of 41.5 × 108.0 × 97.6 cm without identifying their orientation or a usable lifting height. Its existing 2,000 lb advertisement is not a verified working-load limit. Read that product's disclosures and confirm the exact rated load, cradle dimensions and assembly requirements with support before ordering; these figures are not specifications for the other jacks.

Read the supplied setup and operating instructions before loading. Inspect the frame, handle, joints, fasteners and contact surfaces, and stop if the jack shifts or a part is loose, deformed or damaged. Check the lining and foot materials actually fitted to your model rather than assuming every jack has UHMW liners or rubber feet. Clean and store the unloaded equipment according to its materials and finish; a liner or foot pad does not guarantee that every bar or floor will remain unmarked.

Check the selected package

Compare the compact lever, set-of-2 option and stand by their own contents. Confirm assembly parts and included accessories before choosing a package.

Confirm bar and cradle fit

Check the actual contact diameter, permitted position, usable lift and operating clearance. A 2-inch plate label is not a measurement of the jack's cradle.

Verify load and condition

Use the load and setup permitted by the exact model's instructions. Inspect the frame, fasteners and contact surfaces; an advertised capacity does not establish a tested working-load limit.

Filter products

Pack / Set